Think your washing machine is not working due to a fuse problem? There is no need to take radical steps until everyone finds out.
The fact is that many users confuse this detail with a surge protector. Indeed, an anti-interference filter acts as a kind of protective element that eliminates interference that can destabilize the operation of other devices and equipment.
In this article we will tell you where the fuse is located in your washing machine.
Where to look for a fuse
The fuse is located on the control board.
Many foreign AGR collected in Europe are equipped with fuses without fail, without them washing machines are prohibited. But in the models of Russian and Chinese production, the installation of such parts is calculated in isolated cases.
Therefore, your model may not have a washing machine. We will talk about where to find the fuse below.
Search details
In various models of washing machines, it can not only look different, but also can be located in different places. If you do not want to delve into the washing machine for a long time, find the electrical circuit that corresponds to this brand. The location of the item will be clearly indicated there. If you cannot find the circuit, you will have to inspect the places where the fuse could be supposed to be. Check:
- Inside the plug from the mains wire.
- At the end of the wire is the network connection that is inside the case.
- On or near the electronic board.
For a thorough inspection, remove the top cover of the CM. Unscrew the two screws located at the back, push the cover in the opposite direction and remove. What the fuse looks like is shown in the photo below.
If you are unable to find the part, it may not be in your model.
Causes and signs of damage
If the washing machine stops working or is completely turned off, while the power is not supplied, the cause may be a faulty fuse. It could burn out as a result of a sharp surge in voltage. The principle of its operation is to protect the control board during network outages. And since this is not uncommon in our electric networks, the equipment suffers first of all.
Is it worth repairing
Before doing repairs, you need to think about how to check the fuse. You can run the test with a tester with a multimeter. These details may be different in appearance, but they are checked the same way.
Do the work in the following order:
- Set your tester to resistance measurement mode.
- Disconnect the fuse from the element on which it is located.
- Press the tester probes to the contacts of the element.
- Look at the readings on the screen.
- A healthy item will show 0 OM. If the tester did not show anything, then a malfunction has occurred.
A malfunction may indicate a short circuit in the electronic circuit of the washer: for example, a heating element has closed. It is necessary to check everything properly. Is it worth it to replace the fuse with your own hands? It cannot be repaired, and manipulations with the electronic board can lead to an undesirable effect. Therefore, in this case, it is better to contact the master. A video on the topic will help you do an independent check: