Any equipment needs cleaning and maintenance. Dirt, mold, debris - all this accumulates in the holes and parts of the washer, harming the health of the user and the operation of the machine. The vertical loading washing machine is cleaned at home. How to do it?
The instructions will help to carry out the work:
A clean top-loading washing machine on the outside is operational.
But it is enough to flip the lid and bend the cuff, as you can see the mold and fungus that have been seated in the grooves for a long time. Over time, this leads to damage to the equipment. After all, if mold is visible from the outside, then inside the heater it could be covered with no lesser scale layer. Some models report a problem with an error code. If the “Service” is lit in the Virpul washers on the display, then it is necessary to check the internal details of the machine.
Take a Phillips screwdriver and remove the screws around the perimeter. In the model BOSCH max 5 there are 4 pieces.
Remove the powder container. Dirt also lurks inside.
Remove the top of the hatch. This is what the cover hides.
Take citric acid.
Using a brush, cover the problem areas with lemon powder: the cuff of the hatch, the space under the cuff, the powder cuvette.
Remove the drain filter from the tank and rub it with citric acid.
Remember to clean the drum itself.
Next, install the program at a temperature of 90 degrees. After about an hour, stop the program. During this time, the water managed to warm up well. Leave the car in this condition overnight. In the morning, run the program again and end the cycle.
So with the help of simple citric acid, you can get rid of scale, mold and fungus. The procedure must be performed at least 1 time in 2-3 months. Video will help to understand the intricacies of cleaning: